Infared BGA Reballing Station T870A, bga rework station
Maintenance and overhaul:
1, Complete machine maintenance:
After the machine has been used for a period of time, clean the focusing frame, the guide
rod, the PCB board support and the sliders and treat them with a lubricant to protect them
from rust.
2, Preheating chassis and infra-red lamp body maintenance:
Clean the pre heating chassis and in particular the infrared lamp body with dehydrated
alcohol. Otherwise residue from evaporated soldering paste could otherwise decrease
the effectiveness of the infrared lamp.
3, Infra-red lamp replacement:
Use a special inside caliper gauge or a pair of long mouth pliers to first take out
the inside spring. Then push the lamp gently out of the body through the air vent
Features
1. Adopt infrared weld technology which independent exploration.
2. Use infrared heat, easy to cut through, heat proportion piercing tradition weld machine with sirocco.
3. Easily operate. Just need one day training. Can operation this machine.
4. Don't need weld tools. This machine can weld all the component of 35-50cm.
5. This machine has 800W heating system. Widely to240x180mm.
6. Infrared heating don't have sirocco flow. Don't impact perimeter small component. Can suitable for all component, especially Micro BGA component.
7. Definitely can satisfy the computer, the notebook, the electricity swims and so on the BGA sealing off/repairs to request. Specially especially suits to the computer north and south bridge.
Technic parameter
Work floor size 360X240mm
Rated voltage and frequency AC220-230V 60/50Hz
Complete machine power 1000W
Infra-red lamp body power 150W
Preheating chassis power 800W
Infra-red lamp body heating size Φ 70mm(50x50mm)
Preheating chassis preheating size 240x180mm
Infra-red lamp body temperature adjustable 200-350
Preheating chassis temperature adjustable 60-200
Audited Supplier 
){kind=link}
){kind=link}